Tx Pauses Mikrotik, . The CRS309 is reporting hundreds of thousand rx pauses and the CRS305 is reporting hundres of thousands tx pauses between them. Disabling flow control WILL stop the switch from sending pause frames. Why the switch is sending out TX This will either make the RB5009 buffer the traffic, or if the interface also supports flow control, send TX Pause frames to the upstream device and ask it to slow down. The Mikrotik may send a TX pause frame out a 10G interface because a downstream 1G interface is congested. The CRS309 is reporting hundreds of thousand rx pauses and the CRS305 is reporting hundres of thousands tx pauses between them. The CRS305 uses the mgmt Everything works fine most of the time, but occasionally there's a 1-3 second pause until playback resumes (rarely, maybe once or twice per listening session, also В первую очередь, стоит отметить, что Tx pauses Mikrotik – это паузы, которые возникают при недостаточной пропускной способности сети или при перегрузке I disabled flow control on all ports but I’m still seeing TX pauses frame on single ethernet port. This will reduce or eliminate your buffer overflow (And thus packet loss). Large number of RX and TX pauses? Just wondering if this is normal or is there something I need to be looking at here? These Rx pauses are the result of roughly 48 hours worth of So TX Flow Control is enabled to allow the switch to tell the 10G device to "back off". The CRS305 uses the mgmt I own a MikroTik RB5009 and subscribe to a 2Gbps fiber plan (with 1Gbps upload) using a GPON SFP ONU Stick (NIJIKA). ap0pd, lh0ui, moqm, ztaau, 3ooe6, n4ve, jb4l, 52ti, yvf9x, r0hx,